Goblet door installation method 10 small steps to accomplish easily

The glass door is a special door in your life. It is a good door. The glass included in the current glass door is especially divided into tempered glass and ordinary float goblet, and generally has a new thickness of 12 mm (mm). Manufactured from glass, it is durable with tempered glass. So it is very safe. And now the glass doors are made of clear glass, and they have very good lighting performance. Then, Xiaobian will inform you of the knowledge of your glass door, and I hope that it'll be very helpful to all people.

Glass door installation procedure

1. Positioning of that pay-off: The glass door combined with the fixed glass along with the movable insulated glass door leaf is usually uniformly positioned for location.

2. Limiting groove with the top of the hanging frame: The width of the limiting slot should be a lot more than 2-4mm for the goblet thickness and 10-20mm for the groove depth. When putting in, firstly pull out each metal decorative board edges from the drawn line, and then press along side it line to install the limit slot for the top of the front door frame.

3. Install the wooden bottom from the metal veneer: first fix the square wood about the ground, then stick the metal veneer for the wood with the common glue. The square wood is often directly nailed to your pre-embedded wooden brick, or through the expansion bolt. The means of connection is fixed.

SEVERAL. Install the vertical doorway frame: connect the center distinct the bullet to that door frame, then utilize plywood to determine the contour and position of that door frame column, last but not least wrap the metal attractive surface.

5. Install the particular glass: use a goblet suction cup machine that will suck the thick tumbler, then hold the suction cup to lift the heavy glass plate by 2-3 men and women and move it into the installation position.

6. Permanent glass: Two small square wooden strips for the bottom and side with the wooden block are placed at the center door, the square wood strip is about 4mm away from the glass plate surface, after which you can the universal glue is painted within the square wooden strip. The facing metal is stuck around the square strip.

7. Treatment glass seal: In the gap between the most notable limit groove and the bottom bracket, and the gap among the thick glass as well as the frame column, the magnifying glaas seal is injected.

6. Docking between glass: When the fixed component to the glass door has to be spliced by the oversize, the seam requires a width of 2-3mm, as well as the edge of the glass should be chamfered.

9. Installation of moving glass door leaf: Prior to door leaf is fitted, the grounding spring and the positioning pin on the top part surface of the door frame must be positioned and installed. Both must be coaxial. Check the vertical collection during installation to ensure the biggest market of the ground spring shaft as well as positioning pin. The lines are within the same line.

10. Put in the glass door leaf top and lower door clamps: Install the upper and lower metal door clips within the upper and lower ends on the glass door and measure the height of the door.

Today's glass doors are common in our life, and there are many different kinds of glass doors, like decorative glass doors, health and safety glass doors, energy-saving magnifying glaas doors, coated glass entrances, induction glass doors, et cetera. But no matter which type of glass door has very good noise reduction performance, windproof operation, dustproof performance and so on. Therefore, it is traditional in many industries, for example hotels, hotels, banks, business office buildings, hospitals, shops, and so forth.,and the most commonly used is the pedal-sensing magnifying glaas door.